Temporary Chain Link Fence vs. Panel Fence: Which Is Best for Your Job Site?

Nov. 172026

A temporary chain link fence is the default way to secure a job site, but the real decision is whether it should be roll fence or panel fence. Both are chain link, and the difference is how each one stands, what ground it suits and how easily it moves.

At Knight’s, the chain link versus panel question comes down to two products. Roll fence is 6 ft tall by 12 ft wide chain link on in-ground poles, and panel fence is chain link panels on stands in 6 ft and 8 ft heights. Knight’s rents both from Bakersfield, Fresno, Stockton and Rancho Cordova, and Central Valley wind and open ground often settle the choice.

A temporary chain link fence is chain link mesh in rentable sections that goes up for the length of a project and comes down when it ends. There is no concrete and no permanent footing. Our guide to temporary fencing types and uses covers the basics, and the temporary fence rental page lists everything Knight’s offers.

Roll fence

Roll fence comes in 6 ft tall by 12 ft wide sections. Its poles are pounded into the ground for support, so it suits open soil and long runs around a lot or a work zone.

Panel fence

Panel fence comes as 6 ft or 8 ft tall chain link panels, 12 ft wide, set on stands. The stands rest on the surface, so nothing is driven into asphalt, concrete or hard ground, and panels can be reconfigured if the site layout changes. Choose 8 ft panels where extra height matters.

Roll fence vs panel fence side by side

Here is how the two styles compare on the points that usually decide the order.

Feature Roll fence Panel fence
Height 6 ft 6 ft or 8 ft
Section width 12 ft 12 ft
How it stands In-ground poles Stands on the surface
Best surface Open soil Soil, asphalt or concrete
Layout changes Poles must be reset Panels move on their stands

Roll fence and panel fence from Knight’s Site Services.

Start with the ground, then the height, then how long the layout will stay the same.

  • Open dirt lot with a long perimeter: roll fence
  • Paved lot, slab or yard where digging is not allowed: panel fence
  • Extra height or tighter security: 8 ft panel fence
  • Layout that will change as the project moves: panel fence

Most sites that order a temporary chain link fence mix the two, with roll fence along open edges and panels near pavement, gates and work areas. For crews on active builds, our construction fence rental guide goes deeper, and Knight’s construction industry page shows the other services that go with it.

Knight’s Site Services · Bakersfield, CA

Send us your address, the length of fence you need and how long the project will run, and we will put together a free quote.

Request a free quote

Gates, privacy screens and wind ballast

Fence is only useful if people and trucks can get through it. Knight’s offers a 6 ft by 6 ft pedestrian gate, a 6 ft by 12 ft utility gate and a 6 ft by 24 ft vehicle gate. Mesh privacy screen in green or tan hides equipment and activity from the street.

Wind across Kern County and the San Joaquin Valley can push over an unballasted line, so gravel bags and security clamps are part of the setup, not an extra. Tell Knight’s about open ground and exposed corners so the crew plans ballast for them.

Planning for crowds instead of crews? Our event fencing guide covers lanes, gates and emergency access.

Safety, permits and site rules

Fencing is one part of a site safety plan. Check requirements with Cal/OSHA alongside federal OSHA, your city or county and the property owner, and ask about permits before you order.

Knight’s offers 24-hour emergency services if something goes wrong after hours. If the crew needs restrooms on the same site, Knight’s portable restrooms can be scheduled alongside the fence.

Common fence mistakes to avoid

Most fence problems come from the plan, not the product. These are the ones we see most often:

  • Skipping ballast in open, windy areas, so panels lean or fall
  • Ordering a pedestrian gate when trucks need a vehicle gate
  • Measuring the perimeter too tightly and leaving no room for corners and gates
  • Choosing roll fence for a paved area where poles cannot be driven

Each one is easy to avoid when the fence type, gates and ballast are chosen together. A quick call to Knight’s before you order can save a second delivery.

Planning the fence line before delivery

A few minutes of planning keeps the install quick and the fence in the right place.

  • Walk the perimeter and note slopes, curbs, trees and anything that will block a straight run
  • Mark where trucks, crews and visitors will enter, then size each gate to its traffic
  • Check the ground type so you can choose roll fence for soil and panel fence for pavement
  • Call 811 before any poles are driven into the ground

Share a rough sketch or a property address with Knight’s, and the crew can recommend the number of sections, the gate placement and the ballast needed for your site.

Why contractors rent from Knight’s

Renting a fence means no storage between jobs and no need to own equipment you use only part of the year. Knight’s has served California for over 40 years as a family-owned company, with about 100 associates, four locations and service across more than 35 counties.

That reach helps when a project has sites in more than one city, because one provider can deliver fence, gates and restrooms across the Central Valley and Northern California.

Knight’s does not publish a flat price, because no two sites match. A quote for a temporary chain link fence follows these variables:

  • Roll fence or panel fence, and the height
  • Total linear footage
  • Number and size of gates
  • Privacy screen or no screen
  • Rental length, delivery location and ground conditions

Our temporary fence rental cost breakdown explains how each variable moves the price.

Frequently asked questions

What is the difference between roll fence and panel fence?

Both are chain link. Roll fence is 6 ft tall and 12 ft wide on in-ground poles. Panel fence comes in 6 ft and 8 ft heights, 12 ft wide, on stands that rest on the surface.

Can a temporary chain link fence go on concrete or asphalt?

Yes, as panel fence. The stands sit on the surface, so nothing is driven into the ground. Roll fence uses poles pounded into the soil, so it suits open ground.

How tall is a temporary chain link fence?

Knight’s rents roll fence and panel fence at 6 ft tall, and panel fence is also available at 8 ft. Gates are 6 ft tall in pedestrian, utility and vehicle widths.

Does a temporary fence need wind protection?

In the Central Valley, yes. Gravel bags and security clamps help keep panel lines upright in the wind that crosses Kern County and the San Joaquin Valley.

Tell us what you are fencing, and we will recommend the right mix of roll fence, panel fence, gates and screens. Contact Knight’s Site Services or call 866-864-5380 to set up your fence in Bakersfield, Fresno, Stockton or Rancho Cordova.

Event fencing turns an open field or parking lot into a venue with a clear entrance, a clear edge and a plan for where people go. For organizers in Bakersfield, Fresno, Stockton and Rancho Cordova, the right setup keeps crowds...
A construction fence rental gives your project a physical boundary before the first crew arrives and keeps it in place until the last truck leaves. For contractors across Bakersfield, Fresno, Stockton and Rancho Cordova, it is one of the fastest...
Asking how much is temporary fence rental without knowing the variables behind the number is like asking how much a building costs without specifying the size. The fence type, the total linear footage, the rental duration, the gate configuration, the...